Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateWaynton Dalton Cable & Drum Replacement: The Woodland Hills Owner’s Guide
Wayne Dalton cable and drum replacement in Woodland Hills typically runs $130 – $250 installed, and we keep the common Wayne Dalton-compatible drums and cables on our trucks so most jobs are done in a single visit. The failure almost always shows up the same way: you’ll hear a snap or a sharp popping sound, then one side of the door hangs low, crooked, or won’t lift at all. The cable has either snapped or jumped off the drum, and the drum itself is often chewed up in the process.
We’re Marlow Garage Door Repair Woodland Hills, and Wayne Dalton is one of the eight brands our techs are factory-trained on. That matters with this repair because Wayne Dalton doors use a few hardware quirks other brands don’t, and getting the wrong cable length or drum profile turns a $200 fix into a repeat failure six months later.
Which Wayne Dalton Models This Applies To
This repair covers Wayne Dalton’s residential line: the 8000, 9000, and 9100 series (their classic insulated steel doors), the 8300 and 8500 series, the Prodrive and TorqueMaster systems, and most legacy models still installed across the San Fernando Valley. The compatibility gotcha with Wayne Dalton specifically is the TorqueMaster counterbalance system: instead of exposed torsion springs on a bar above the door, it houses the springs inside a tube. If your door has TorqueMaster, the cables and drums are different from standard torsion hardware, and a generic cable-and-drum kit from a big-box store won’t fit correctly. We match the drum profile and cable length to the specific door weight and track radius on your setup.
Identifying your part takes a minute. Look for a label on the door’s inside edge or on the tube near where the cables attach. If the label is gone, we measure the drum diameter and cable length on-site. For most Woodland Hills homes with Wayne Dalton doors, OEM-spec replacement parts make sense on doors under about 12 years old, while a quality aftermarket drum and cable set (same gauge, same drum geometry) works fine on older doors where the original hardware is discontinued. We’ll tell you which way we’re going and why before we start, and the written price you get is the price you pay.
One more thing worth knowing: we’re an independent service company, not affiliated with Wayne Dalton. That’s a good thing for you, because it means we’ll tell you honestly when an aftermarket part does the job for less, or when it’s time to stop feeding repairs into a door that’s at the end of its run.
Styles & brands we work with






Signs Your Wayne Dalton Cable & Drum Replacement Is Failing
- You heard a snap, and the door now sits crooked. A cable snapped under tension. When one cable goes, the remaining cable and drum take the full load and they’re usually not far behind.
- The door hangs unevenly in the tracks, even after you try to straighten it. A frayed or stretched cable means one side pays out differently than the other, and no amount of re-balancing will fix a stretched steel cable.
- You see visible fraying or loose strands on the cable. Steel cable doesn’t fray without a reason. The cause is usually a worn drum with a sharp groove edge or a misaligned track scraping the cable over time.
- The drum has a visible groove worn deeper than the cable diameter. Once the drum’s winding surface is scored, the cable seats unevenly, builds up friction, and snaps early. This is the classic Woodland Hills failure we see after several dry, hot summers where doors cycle more often.
- You hear grinding or squeaking when the door moves, and the cables don’t wind cleanly. The drum and cable are fighting each other. If you keep running the door, the cable will jump the drum entirely and the door can bind hard.
Replacement Cost & What’s Included
Cable and drum replacement on a Wayne Dalton door in Woodland Hills typically runs $130 – $250 installed, parts and labor together. That range reflects the type of drum your door uses, whether you have the TorqueMaster system (which costs a bit more because of the specific drum profile), and whether one or both sides need attention. Most of the time, when one side has failed, the other cable and drum are at the same point in their wear cycle, and we’ll show you what we’re seeing so you can decide.
Here’s the honest breakdown:
| Item | Typical Installed Range |
|---|---|
| Cable replacement (single side) | $130 – $190 |
| Cable and drum replacement (single side) | $170 – $220 |
| Cable and drum replacement (both sides) | $190 – $250 |
Every quote is written and locked before any work begins, so the invoice number and the quote number are the same. The 365-Day Done Right Promise covers every cable and drum replacement we perform in Woodland Hills: if the cable fails, the drum slips, or anything about the repair isn’t right within a full year, we come back and make it right at no charge. That’s in writing, not in the fine print.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things yourself: look at the cable for visible fraying, see if the drum has a deep groove worn into it, and confirm which side of the door is hanging low. What you should not do is attempt to replace a cable or drum yourself. Those cables are under extreme tension from the springs, and when a cable snaps or releases, it moves fast enough to cause serious injury. The drum windings and cable set-screws on a Wayne Dalton door are also a specific fit, and if the drum slips after a DIY install, the door is coming down hard. We handle this repair daily in Woodland Hills, including plenty of steep-driveway homes near Warner Center where older Wayne Dalton hardware is still doing its job. If the door is hung up and you’re not sure what to do next, call us at (341) 888-6519. We’ll walk you through what you’re looking at and get you on the schedule.
Tell me what it’s doing wrong – I’ll tell you exactly what it needs and what it costs. No runaround.
FAQs
In Woodland Hills, Wayne Dalton cables and drums typically last 8 – 12 years, but the dry heat and the frequency of door cycles can shorten that to as little as 6 years on doors that open and close multiple times daily. If your door is over 10 years old and you’re seeing the first signs of cable wear, replacing both sides at once usually makes more sense than waiting for the other side to fail on its own.
No, a snapped cable or a worn drum is a replacement item, not a repair item. Steel cable can’t be safely spliced, and a scored drum can’t be machined smooth on-site. The good news is that replacement is quick and the parts are affordable. Call (341) 888-6519 for an exact quote, and we’ll show you the written price before any work starts.
Most Wayne Dalton cable and drum replacements in Woodland Hills take 60 – 90 minutes on-site. That includes removing the old hardware, installing the new cable and drum, re-tensioning the system, and testing the door through several full cycles. We carry the common Wayne Dalton drum profiles and cable lengths on the truck, so the swap usually happens in one visit.
Yes, we stock the common Wayne Dalton drum profiles and cable lengths for the 8000, 9000, 9100, and TorqueMaster systems on our trucks. That’s a direct benefit of Marlow being trained on eight major brands, including Wayne Dalton, LiftMaster, Chamberlain, and Genie. When the part is on the truck, the repair is done today, and the price you were quoted is the price on the invoice. Call us at (341) 888-6519 for a free estimate.
Get Your Wayne Dalton Door Fixed Today
If your Wayne Dalton garage door is hanging crooked, making a grinding noise, or the cable has snapped, we can get it back in service fast. We’re Marlow Garage Door Repair Woodland Hills, trained on eight major brands, with the Wayne Dalton parts on the truck and the written price in your hand before any wrench turns. Call (341) 888-6519 for a free estimate or to book your repair, or schedule online in seconds and track your tech on the way. We’re available 24/7 for emergencies, and a real person answers every call.
Written by Jaylen Ross, Owner, Marlow Garage Door Repair Woodland Hills at Marlow Garage Door Repair Woodland Hills, serving Woodland Hills and nearby areas.